STS-60 Kit
Each kit includes two sensors, a processor and an AC adapter
Note: This adapter is 10 Watts.
Not all similar adapters are 10 Watts.
You’ll need to lift the mattress to install the sensors.
The sensors go under the mattress, directly beneath the pillow area, firmly sandwiched between the mattress and bed.
The sensor goes under the mattress…
... not under the pillow itself
You’ll need both sensors with two people in bed or with one person and a pet
Plug the black sensor into port 1 and the blue sensor into port 2.
Align sensors near the outer edge of each pillow, away from your bed partner.
Side of bed matters. Install according to the diagram.
One person uses only one sensor:
Plug one sensor into port 1, centering it relative to your pillow. The second sensor is not used and should remain unplugged.
Plug the processor into a power outlet using the supplied 10 Watt power supply.
Note: This adapter is 10 Watts.
Not all similar adapters are 10 Watts.
For slatted, grid, or mesh bed frames:
Place each sensor on a solid, flat surface near the outer edge of your pillow. The entire foam sensor must press firmly and evenly into the mattress—not sit partly over a gap.
If the openings are larger than the sensor, place a thin piece of plywood or plexiglass underneath to bridge the gaps.
